Category: CCNA 2 v4.0 – Routing Protocols and Concepts

CCNA 2 v4.0 – Routing Protocols and Concepts

CCNA 2 Practice Final Exam Answers v4.0 100%

1. Refer to exhibit .The network is using the RIPv2 routing protocol.If network 10.0.0.0 goes down ,what mechanism will prevent Router1 from advertisting false routing information back to Router2? triggered updates poison reverse holddown timers split horizon 2.Refer to exhibit.All routers are advertised and fully operational on all …

CCNA 2 Final Exam Answers v4.0 100%

CCNA 2 Final Exam Answers v4.0 100% PDF Download 1. Refer to the exhibit. The network consists of hundreds of routers branched from connected regional distribution sites using single area OSPF. Recent network failures caused packet flooding and route recalculations in all branch networks. What should the engineer …

CCNA 2: Practice SBA EIGRP Answers V4.0 100%

// E-Branch 2 conf t hostname EB2 enable secret class line console 0 password cisco login exit line vty 0 4 password cisco login exit banner motd %Authorized access only!% int f 0/0 ip add 192.168.1.1 255.255.255.192 no sh int f 0/1 ip add 192.168.1.65 255.255.255.192 no sh …

CCNA 2: Chapter 11 Exam Answer v4.0 100%

1. What is the default administrative distance for OSPF?90100110115120 2.Refer to the exhibit. What is the cost of the route to the 10.0.0.0 network?211017861.544 3.Refer to the exhibit. What configuration statements would give the results that are shown in the output of the show ip protocols command?B(config)# int …

CCNA 2: Chapter 10 Exam Answer v4.0 100%

1. Refer to the exhibit. What does JAX do with link-state packets from ORL?sends out its updated routing table to both ORL and BOS routerssends out the individual link-state packets out the interface connected to BOSqueries BOS to see if it has a better routeonly adds it to …

CCNA 2: Chapter 9 Exam Answer v4.0 100%

1.Refer to the exhibit. The company is using EIGRP with an autonomous system number of 10. Pings between hosts on networks that are connected to router A and those that are connected to router B are successful.However, users on the 192.168.3.0 network are unable to reach users on …

CCNA 2: Chapter 8 Exam Answer v4.0 100%

1.The following entry is displayed in the routing table:R 192.168.8.0/24 via 192.168.4.1, 00:00:26, Serial0/0/1What type of route is this?a level 1 parent routea level 1 supernet routea level 1 ultimate network routea level 2 child routea level 2 ultimate child route 2.Refer to the exhibit. Which statement correctly …

CCNA 2: Chapter 7 Exam Answer v4.0 100%

1. What field was added to the RIP message header by RFC 1723 to add support for VLSM and CIDR?subnet maskdestination port numberaddress family identifiersource and destination IP addresses 2. Refer to the exhibit. What can be concluded from the output shown in the exhibit?The routing table is …

CCNA 2: Chapter 6 Exam Answer v4.0 100%

Take Assessment – ERouting Chapter 6 – CCNA Exploration: Routing Protocols and Concepts (Version 4.0) – Answers – 2012 – 2013 1. What two advantages does CIDR provide to a network? (Choose two.)reduced routing table sizedynamic address assignmentautomatic route redistributionreduced routing update trafficautomatic summarization at classful boundaries 2.Refer …