Category: CCNA 3 v4.0 – LAN Switching and Wireless

CCNA 3 v4.0 – LAN Switching and Wireless

CCNA 3 – Practice Final Exam Answers v4.0 100%

1 Refer to the exhibit. After receiving a console notification on Switch2, the network administrator begins to troubleshoot the trunk link between Switch1 and Switch2. Which configuration change can be made to correct the problem with the trunk link? Set the Fa0/1 interface on Switch2 to trunk mode. …

CCNA 3: Final Exam Answers v4.0 100%

CCNA 3 Final Exam Answers v4.0 100% PDF Download 1. Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.65 and a destination address of 192.168.1.161. What will the router do with this packet? The router will drop the packet. The router will …

CCNA 3: Chapter 7 Exam Answer v4.0 100%

1. Which two statements concerning network security are accurate? (Choose two.) 802.11i uses 3DES for encryption. Open authentication uses no client or AP verification. The 802.11i protocol is functionally identical to WPA. 802.11i incorporates a RADIUS server for enterprise authentication. A wireless client first associates with an AP …

CCNA 3: Chapter 6 Exam Answer v4.0 100%

1. What are the steps which must be completed in order to enable inter-VLAN routing using router-on-a-stick?Configure the physical interfaces on the router and enable a routing protocol.Create the VLANs on the router and define the port membership assignments on the switch.Create the VLANs on the switch to …

CCNA 3: Chapter 5 Exam Answer v4.0 100%

1. Which two criteria does a switch use to select the root bridge? (Choose two.)bridge priorityswitching speednumber of portsbase MAC addressswitch locationmemory size 2. Which two statements are true about the default operation of STP in a Layer 2 switched environment that has redundant connections between switches? (Choose …

CCNA 3: Chapter 4 Exam Answer v4.0 100%

1.Refer to the exhibit. S2 was previously used in a lab environment and has been added to the production network in server mode. The lab and production networks use the same VTP domain name, so the network administrator made no configuration changes to S2 before adding it to …

CCNA 3: Chapter 3 Exam Answer v4.0 100%

1.Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet range. Computer A can communicate with computer B, but not with computer C or computer D. What is …

CCNA 3: Chapter 2 Exam Answer v4.0 100%

1.Refer to the exhibit. Which hosts will receive a broadcast frame sent from Host A?hosts A and Bhosts B and Chosts D and Ehosts A, B, and Chosts B, C, D, and Ehosts A, B, C, D, E, and F2. Which command line interface (CLI) mode allows users …

CCNA 3: Chapter 1 Exam Answer v4.0 100%

1. Refer to the exhibit. What characteristic of hierarchical network designs is exhibited by having SW3 connected to both SW1 and Sw2? scalability security redundancy maintainability 2. Which two characteristics are associated with enterprise level switches? (Choose two.) low port density high forwarding rate high latency level support …