Category: CCNA v7 Course #3

CCNA 3 Module 13 Quiz – Network Virtualization (Answers)

1. A company uses a cloud-based payroll system. Which cloud computing technology is this company using? infrastructure as a service (IaaS) wireless as a service (WaaS) software as a service (SaaS) browser as a service (BaaS) 2. For a data center, what is the difference in the server …

CCNA 3 Module 12 Quiz – Network Troubleshooting (Answers)

1. Which statement describes the physical topology for a LAN? It depicts the addressing scheme that is employed in the LAN. It describes whether the LAN is a broadcast or token-passing network. It defines how hosts and network devices connect to the LAN. It shows the order in …

CCNA 3 Module 11 Quiz – Network Design (Answers)

1. Which cost-effective physical network topology design is recommended when building a three-tier campus network that connects three buildings?​ mesh dual ring extended star bus 2. How much traffic is a 48-port gigabit switch capable of switching when operating at full wire speed? 48 Gb/s, by providing full …

CCNA 3 Module 10 Quiz – Network Management (Answers)

1. What are two reasons for an administrator to issue the copy running-config tftp command on a switch or router? (Choose two.) to force an automatic reload of the device to have a backup of the running configuration file in the router to overwrite the current configuration to …

CCNA 3 Module 9 Quiz – QoS Concepts (Answers)

1. What is the term used to indicate a variation of delay? speed mismatch serialization delay jitter latency 2. A network engineer performs a ping test and receives a value that shows the time it takes for a packet to travel from a source to a destination device …

CCNA 3 Module 7 Quiz – WAN Concepts (Answers)

1. A company is expanding its business to other countries. All branch offices must remain connected to corporate headquarters at all times. Which network technology is required to support this scenario? LAN WLAN MAN WAN 2. What is the recommended technology to use over a public WAN infrastructure …

CCNA 3 Module 6 Quiz – NAT for IPv4 (Answers)

1. Which two statements accurately describe an advantage or a disadvantage when deploying NAT for IPv4 in a network? (Choose two.) NAT adds authentication capability to IPv4. NAT introduces problems for some applications that require end-to-end connectivity. NAT provides a solution to slow down the IPv4 address depletion. …

CCNA 3 Module 4 Quiz – ACL Concepts (Answers)

1. Which two conditions would cause a router to drop a packet? (Choose two.) The ACL that is affecting the packet does not contain at least one deny ACE. No routing table entry exists for the packet destination, but the packet matches a permitted address in an outbound …