Category: CCNPv8 ENARSI
1. What is the first attribute to be used in determining the best path when a BGP router has multiple paths for the same network prefix length? weight lowest MED local originated local preference 2. Refer to the exhibit. A network administrator in autonomous system 65100 has set …
1. What is the correct BGP command to summarize the addresses from 172.16.0.0 through 172.16.15.0 into a single address that will be advertised by BGP? summary-address 172.16.0.0 0.15.255.255 summary-only summary-address 172.16.0.0 255.255.240.0 summary-only aggregate-address 172.16.0.0 0.15.255.255 summary-only aggregate-address 172.16.0.0 255.255.240.0 summary-only 2. A network administrator is configuring a …
1. Which transport layer port is used in BGP peering? UDP port 289 TCP port 289 UDP port 179 TCP port 179 2. Which routing protocol is used to exchange routing information between autonomous systems on the Internet? IS-IS EIGRP OSPF BGP 3. Refer to the exhibit. A …
1. Which command will verify that a router that is running OSPFv3 has formed an adjacency with other routers in its OSPF area? show running-configuration show ipv6 ospf neighbor show ipv6 route ospf show ipv6 interface brief 2. Refer to the exhibit. Which would be chosen as the …
1. Which two OSPFv3 LSA types are used to advertise IPv6 unicast address prefixes and prevent the need for SPF calculations every time an address prefix is added or changed on a router interface? (Choose two.) LSA type 4 – inter-area router LSA type 5 – AS-external LSA …
1. Which command should be used to check the OSPF process ID, the router ID, networks the router is advertising, the neighbors the router is receiving updates from, and the default administrative distance? show ip protocols show ip ospf neighbor show ip ospf show ip ospf interface 2. …
1. Which characteristic describes both ABRs and ASBRs that are implemented in a multiarea OSPF network? They usually have many local networks attached. They both run multiple routing protocols simultaneously. They are required to perform any summarization or redistribution tasks. They are required to reload frequently and quickly …
1. Refer to the exhibit. Which conclusion can be drawn from this OSPF multiaccess network? When a DR is elected all other non-DR routers become DROTHER. All DROTHER routers will send LSAs to the DR and BDR to multicast 224.0.0.5. If the DR stops producing Hello packets, a …
1. Refer to the exhibit. An administrator attempts to configure EIGRP for IPv6 on a router and receives the error message that is shown. Which command must be issued by the administrator before EIGRP for IPv6 can be configured? no shutdown eigrp router-id 100.100.100.100 ipv6 unicast-routing ipv6 eigrp …
1. Refer to the exhibit. Which two conclusions can be derived from the output? (Choose two.) There is one feasible successor to network 192.168.1.8/30. The network 192.168.10.8/30 can be reached through 192.168.11.1. The reported distance to network 192.168.1.0/24 is 41024256. The neighbor 172.16.6.1 meets the feasibility condition to …