Refer to the exhibit. A network architect has partially configured static NAT. which commands should be asked to complete the configuration?

January 25, 2021 Last Updated: January 25, 2021 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNP › Refer to the exhibit. A network architect has partially configured static NAT. which commands should be asked to complete the configuration?
0
Vote Up
Vote Down
Refer to the exhibit. A network architect has partially configured static NAT. which commands should be asked to complete the configuration? 1ITExamAnswers Staff asked 5 months ago

Question:
Refer to the exhibit. A network architect has partially configured static NAT. which commands should be asked to complete the configuration?

Refer to the exhibit. A network architect has partially configured static NAT. which commands should be asked to complete the configuration? 2

R1(config)# ip nat inside source static 10.70.5.1 10.45.1.7

A.
R1(config)#interface GigabitEthernet0/0
R1(config)#ip pat outside
R1(config)#interface GigabitEthernet0/1
R1(config)#ip pat inside

B.
R1(config)#interface GigabitEthernet0/0
R1(config)#ip nat outside
R1(config)#interface GigabitEthernet0/1
R1(config)#ip nat inside

C.
R1(config)#interface GigabitEthernet0/0
R1(config)#ip nat inside
R1(config)#interface GigabitEthernet0/1
R1(config)#ip nat outside

D.
R1(config)#interface GigabitEthernet0/0
R1(config)#ip pat inside
R1(config)#interface GigabitEthernet0/1
R1(config)#ip pat outside

More Questions: CCNP 350-401 Dumps


Related Articles