Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?

January 24, 2021 Last Updated: January 24, 2021 No Comments
Tweet Share Pin it
IT Questions Bank › Category: CCNP › Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?
0
Vote Up
Vote Down
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem? 1ITExamAnswers Staff asked 1 month ago
Question:
Refer to the exhibit.

Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem? 2

A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish. Based on the configuration except of SW3, what is the cause of the problem?

  • A. The port-channel mode should be set to auto.
  • B. The port channel on SW2 is using an incompatible protocol.
  • C. The port-channel trunk is not allowing the native VLAN.
  • D. The port-channel interface load balance should be set to src-mac.

Explanation: The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

More Questions: CCNP 350-401 Dumps


Related Articles