Refer to the exhibit. These commands have been added to the configuration of a switch. Which command flags an error If It is added to this configuration?

IT Questions BankCategory: CCNPRefer to the exhibit. These commands have been added to the configuration of a switch. Which command flags an error If It is added to this configuration?
Refer to the exhibit. These commands have been added to the configuration of a switch. Which command flags an error If It is added to this configuration? 1ITExamAnswers Staff asked 9 months ago

Question:
Refer to the exhibit. These commands have been added to the configuration of a switch. Which command flags an error If It is added to this configuration?

Refer to the exhibit. These commands have been added to the configuration of a switch. Which command flags an error If It is added to this configuration? 2

  • A. monitor session 1 source interface port-channel 6
  • B. monitor session 1 source vlan 10
  • C. monitor session 1 source interface FastEthernet0/1 rx
  • D. monitor session 1 source interface port-channel 7, port-channel 8

Explanation: A monitor session can source from interfaces or VLANs – not both at the same time.

RSPAN consists of at least one RSPAN source session, an RSPAN VLAN, and at least one RSPAN destination session. You separately configure RSPAN source sessions and RSPAN destination sessions on different network devices. To configure an RSPAN source session on a device, you associate a set of source ports or source VLANs with an RSPAN VLAN.
Traffic monitoring in a SPAN session has these restrictions:
+ Sources can be ports or VLANs, but you cannot mix source ports and source VLANs in the same session.
Reference: Here
Therefore in this question, we cannot configure a source VLAN because we configured source ports for RSPAN session 1 already.

More Questions: CCNP 350-401 Dumps


Related Articles

guest
0 Comments
Inline Feedbacks
View all comments