Which reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?

IT Questions BankCategory: CCNPWhich reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?
Which reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state? 1ITExamAnswers Staff asked 1 month ago
Question:
Which reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?

  • A. mismatched OSPF link costs
  • B. mismatched OSPF network type
  • C. mismatched areas
  • D. mismatched MTU size

Explanation: When OSPF adjacency is formed, a router goes through several state changes before it becomes fully adjacent with its neighbor. The states are Down -> Attempt (optional) -> Init -> 2-Way -> Exstart -> Exchange -> Loading -> Full. Short descriptions about these states are listed below:
Down: no information (hellos) has been received from this neighbor.
Attempt: only valid for manually configured neighbors in an NBMA environment. In Attempt state, the router sends unicast hello packets every poll interval to the neighbor, from which hellos have not been received within the dead interval.
Init: specifies that the router has received a hello packet from its neighbor, but the receiving router’s ID was not included in the hello packet
2-Way: indicates bi-directional communication has been established between two routers.
Exstart: Once the DR and BDR are elected, the actual process of exchanging link state information can start between the routers and their DR and BDR.
Exchange: OSPF routers exchange database descriptor (DBD) packets
Loading: In this state, the actual exchange of link state information occurs Full: routers are fully adjacent with each other (Reference:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080093f0e.s html)
Neighbors Stuck in Exstart/Exchange State the problem occurs most frequently when attempting to run OSPF between a Cisco router and another vendor’s router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces don’t match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighboring router ignores the packet.

Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/166/b_166_programmability_cg/b_166_programmability_cg_chapter_01011.html

More Questions: CCNP 350-401 Dumps


Related Articles