IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNA 2 v4
Which of the following could describe the devices labeled "?" in the graphic? (Choose three.)
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. A network administrator has enabled RIP on routers B and C in the network diagram. Which of the following commands will prevent RIP updates from being sent to Router A?
ITExamAnswers Editorial Team asked 4 years ago • 
A network administrator enters the following command into Router1: ip route 192.168.0.0 255.255.255.0 S0/1/0. Router1 then receives a packet that is destined for 192.168.0.22/24. After finding the recently configured static route in the routing table, what does Router1 do next to process the packet?
ITExamAnswers Editorial Team asked 4 years ago • ,
Which two statements describe characteristics of load balancing? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • , ,
Refer to the exhibit. What destination address will RTB use to advertise LSAs?
ITExam Editorial Team asked 6 years ago • , ,
What is the function of the OSPF LSU packet?
ITExamAnswers Editorial Team asked 4 years ago • ,
A fully converged five router OSPF network has been running successfully for several weeks. All configurations have been saved and no static routes are used. If one router looses power and reboots, what information will be in its routing table after the configuration file is loaded but before OSPF has converged?
ITExamAnswers Editorial Team asked 4 years ago • , ,
Refer to the exhibit. When OSPF is operational and converged, what neighbor relationship is developed between Router1 and Router2?
ITExamAnswers Editorial Team asked 3 years ago • , ,
What does OSPF use to calculate the cost to a destination network?
ITExamAnswers Editorial Team asked 4 years ago • ,
Refer to the exhibit. Based on the output of show ip eigrp neighbors, what are two possible problems with adjacencies between Router1 and Router2? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • , ,
Refer to the exhibit. When troubleshooting a network, it is important to interpret the output of various router commands. On the basis of the exhibit, which three statements are true? (Choose three.)
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. All routers are configured for OSPF area 0. The network administrator requires that R2 always be the DR and maintain adjacency. Which two configurations can achieve this? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • ,
Refer to the exhibit. What will happen if interface Serial0/0/1 goes down on Router1?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. All routers are configured with RIPv2 active on all interfaces. Automatic summarization is in effect. Why does the routing table on R3 include the 209.165.200.228/30 network but not the 172.30.1.0/24 and 172.30.2.0/24 networks?
ITExamAnswers Editorial Team asked 3 years ago • 
Which range of IP addresses will be used by RIPv2, EIGRP, and OSPF routing protocols to send routing advertisements?
ITExamAnswers Editorial Team asked 3 years ago • 
« Previous12345…34Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.