IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNA 3 v4
Refer to the exhibit. Which two switch interfaces would be RSTP edge ports? (Choose two.)
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Which statement is true about the status of interface Fa0/1?
ITExamAnswers Editorial Team asked 4 years ago • 
What is the purpose of configuring a switch port as a trunk port?
ITExamAnswers Editorial Team asked 4 years ago • 
Which type of traffic can still be received on a switch interface that is in STP blocking mode?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. What can be determined from the configuration of this wireless device?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. If switch SW1 is configured with the four VLANs as shown in the exhibit, how many physical interfaces are needed on router R1 to configure inter-VLAN routing using subinterfaces?
ITExamAnswers Editorial Team asked 4 years ago • 
When port security is used on a switch, which violation mode will cause an SNMP trap to be sent and traffic to be dropped when the number of secure MAC addresses for a port is reached?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. An administrator documented the output of a CAM table from an Ethernet switch as shown. What action will the switch take when it receives the frame shown at the bottom of the exhibit?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. A new host needs to be connected to VLAN 1. Which IP address should be assigned to this new host?
ITExamAnswers Editorial Team asked 4 years ago • 
In which mode is a VTP switch operating if it does not allow for the creation of local VLANs but it does accept VLAN updates from other switches in the same domain?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. VTP pruning is enabled in the VTP domain that is shown. How will switch ST-1 handle Layer 2 broadcast traffic originating from host A on switch ST-C?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Which three options correctly identify information that could be associated with this output?(Choose three.)
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. Hosts A and B, connected to hub HB1, attempt to transmit a frame at the same time but a collision occurs. Which hosts will receive the collision jamming signal?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. A network administrator has segmented the network into two VLANs and configured Router1 for inter-VLAN routing. A test of the network, however, shows that hosts on each VLAN can only access local resources and not resources on the other VLAN. What is the most likely cause of this problem?
ITExamAnswers Editorial Team asked 4 years ago • 
Refer to the exhibit. After entering the commands in the exhibit, the administrator receives a “password required, but none set” message when attempting to connect to S1. What is the problem?
ITExamAnswers Editorial Team asked 4 years ago • 
« Previous1…89101112…24Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.