IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNA Discovery v4
Refer to the exhibit. The switches in the exhibit are connected with trunks within the same VTP management domain. Each switch is labeled with its VTP mode. A new VLAN is added to Switch3. This VLAN does not show up on the other switches. What is the reason for this?
ITExamAnswers Editorial Team asked 4 years ago • ,
Which three must be used when a router interface is configured for VLAN trunking? (Choose three.)
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. Switch1 is not participating in the VTP management process with the other switches. Which two are possible reasons for this? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
When are MAC addresses removed from the CAM table?
ITExamAnswers Editorial Team asked 3 years ago • 
A router has two serial interfaces and two Fast Ethernet interfaces. This router must be connected to a WAN link and to a switch that supports four VLANs. How can this be accomplished in the most efficient and cost-effective manner to support inter-VLAN routing between the four VLANs?
ITExamAnswers Editorial Team asked 3 years ago • 
The information contained in a BPDU is used for which two purposes? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
A router is configured to connect to a trunked uplink as shown in the exhibit. A packet is received on the FastEthernet 0/1 physical interface from VLAN 10. The packet destination address is 192.168.1.120. What will the router do with this packet?
ITExamAnswers Editorial Team asked 3 years ago • 
Refer to the exhibit. What two statements can be concluded from the information that is shown in the exhibit? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
What is the maximum recommended cable length for Fast Ethernet over UTP?
ITExamAnswers Editorial Team asked 3 years ago • 
A network administrator has just inserted a new WIC2T controller into the first available slot of an 1841 router. The administrator needs to configure the first serial interface of this new controller. Which interface should be used?
ITExamAnswers Editorial Team asked 3 years ago • 
Which two items protect a corporate network against malicious attacks at the enterprise edge ? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
What device is responsible for moving packets to destination networks outside the local network?
ITExamAnswers Editorial Team asked 3 years ago • 
A Cisco router needs to be configured from a remote location by the use of out-of-band management. Which method should be used?
ITExamAnswers Editorial Team asked 3 years ago • 
Which two pieces of information are documented in a logical topology map? (Choose two.)
ITExamAnswers Editorial Team asked 3 years ago • 
Which type of network map shows the location of hosts, network devices, and media?
ITExamAnswers Editorial Team asked 3 years ago • 
« Previous1…2829303132…86Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.