IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNP
Refer to the exhibit. What does the value 2816 represent in the output display?
ITExamAnswers Editorial Team asked 6 years ago • 
Where should EIGRP summarization be applied?
ITExamAnswers Editorial Team asked 6 years ago • 
Which multicast address does an EIGRP-enabled router use to send query packets?
ITExamAnswers Editorial Team asked 6 years ago • 
Which table is used by EIGRP to store all routes that are learned from EIGRP neighbors?
ITExamAnswers Editorial Team asked 6 years ago • 
Which static path would be the primary default path out of the network?
ITExamAnswers Editorial Team asked 6 years ago • 
Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 What does the 5 at the end of the command signify?
ITExamAnswers Editorial Team asked 6 years ago • 
A network administrator is configuring an EtherChannel trunk link to add additional allowed VLANs to pass the link. Which statement describes the process of this change?
ITExamAnswers Editorial Team asked 6 years ago • 
In which link aggregation mode does an interface initiate EtherChannel negotiation by sending LACP packets?
ITExamAnswers Editorial Team asked 6 years ago • 
Which three parameters must match, on the ports of two switches, for a PAgP Etherchannel to be created? (Choose three.)
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. Which switching technology would allow data to be transmitted over each access layer switch link and prevent the port from being blocked by spanning-tree because of the redundant link?
ITExamAnswers Editorial Team asked 6 years ago • 
What is the effect of entering the switchport mode trunk and switchport nonegotiate interface configuration commands on a Cisco Catalyst 2960 switch that is connected to a switch that does not support DTP?
ITExamAnswers Editorial Team asked 6 years ago • 
Refer to the exhibit. An administrator tried to implement an EtherChannel between two switches by grouping the six physical ports as shown. However, the administrator was not successful. What is the reason for that?​
ITExamAnswers Editorial Team asked 6 years ago • 
What is the default MST region name on Cisco switches?
ITExamAnswers Editorial Team asked 6 years ago • 
What is a solution to mitigate the MST misconfiguration that contains improper VLAN assignment to the IST?
ITExamAnswers Editorial Team asked 6 years ago • 
Which two scenarios are examples of MST region boundaries? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • 
« Previous1…129130131132133Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.