IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNP
Multiple paths exist in the BGP table. Assuming the weights are the same, what will the next determining factor be?
ITExam Editorial Team asked 6 years ago • , ,
Refer to the exhibit. A two-way redistribution is configured on router R2 between the EIGRP and the OSPF domains. The show ip route command output taken on R3 reveals that the network 10.10.10.16/28 is not installed in the routing table. What could be the problem?
ITExamAnswers Editorial Team asked 4 years ago • ,
When would the network administrator use the ip bandwidth-percent eigrp as-number percent command?
ITExamAnswers Editorial Team asked 5 years ago • , ,
How does OSPF exchange routing updates when the passive-interface command is applied?
ITExamAnswers Editorial Team asked 6 years ago • ,
How does Cisco implement interarea OSPF summarization?
ITExam Editorial Team asked 5 years ago • 
If replies are not received from all outstanding queries, how long will an EIGRP router wait before placing a route into the SIA state?
ITExamAnswers Editorial Team asked 5 years ago • ,
When creating an IPv6 static route, when must a next-hop IPv6 address and an exit interface both be specified?
ITExamAnswers Editorial Team asked 6 years ago • ,
A network administrator is teaching a junior network engineer about EIGRP stub routers. Which two explanations can be given to the junior engineer about the subject? (Choose two.)
ITExam Editorial Team asked 5 years ago • 
Which is the correct order of the four steps to configure CoPP on a Cisco router?
ITExam Editorial Team asked 5 years ago • 
A network administrator is configuring IPv6 route summarization on a BGP router with the command aggregate-address 2001:db8::/60 summary-only . Which two component networks match the aggregated route? (Choose two.)
ITExam Editorial Team asked 6 years ago • ,
Refer to the exhibit. A network administrator issues the show bgp ipv4 unicast 10.1.1.128 command on router R2 to verify the network 10.1.1.128 in the BGP table. The administrator notices that there are two paths to reach the network and the path through the neighbor 1.1.1.1 is the best-path. Which configuration step will allow the administrator to change the best path to use neighbor 3.3.3.3?
ITExam Editorial Team asked 5 years ago • 
Which two statements describe the BGP weight attribute? (Choose two.)
ITExam Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator is configuring the syslog service on a Cisco router. Which command should be used to configure an IPv4 address of 192.168.10.254 as the source address on the syslog packets as they exit the router R1?
ITExam Editorial Team asked 5 years ago • 
Refer to the exhibit. A network administrator has configured two-way redistribution on router R1. What metrics will be used for redistributed routes?
ITExam Editorial Team asked 5 years ago • 
In order to limit spoofed packets on a network, a network administrator is configuring uRPF on a Cisco router interface with the ip verify unicast source reachable-via rx command. After the configuration is completed, the administrator observes that valid packets are being dropped. What may be causing this packet discard?
ITExam Editorial Team asked 5 years ago • ,
« Previous1…4243444546…133Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.