IT Exam Items Repository

Last Updated: Jun 24, 2026
IT Exam Items Repository › Category: CCNP
When will a router that is running EIGRP put a destination network in the active state?
ITExamAnswers Editorial Team asked 6 years ago • , ,
What two values must match between two EIGRP directly connected neighbors to establish and maintain an adjacency? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • ,
What does an OSPF area contain?
ITExamAnswers Editorial Team asked 7 years ago • ,
Which address is used by an IPv6 EIGRP router as the source for hello messages?
ITExamAnswers Editorial Team asked 6 years ago • ,
A network administrator is planning to add a new switch to the network. What should the network administrator do to ensure the new switch exchanges VTP information with the other switches in the VTP domain?
ITExamAnswers Editorial Team asked 6 years ago • ,
Refer to the exhibit. All the displayed switches are Cisco 2960 switches with the same default priority and operating at the same bandwidth. Which three ports will be STP designated ports? (Choose three.)
ITExamAnswers Editorial Team asked 6 years ago • ,
Which command can be used by an administrator to display a list of interfaces that are enabled for OSPFv3?
ITExamAnswers Editorial Team asked 6 years ago • ,
Refer to the exhibit. A network administrator has configured OFPF in the topology as shown. What is the preferred path to get from the LAN network that is connected to R1 to the LAN network that is connected to R7?
ITExamAnswers Editorial Team asked 6 years ago • , ,
Which is a characteristic of EtherChannel?
ITExam Editorial Team asked 6 years ago • ,
Refer to the exhibit. The network administrator configures both switches as displayed. However, host C is unable to ping host D and host E is unable to ping host F. What action should the administrator take to enable this communication?
ITExamAnswers Editorial Team asked 6 years ago • , ,
Which statement describes the autonomous system number used in EIGRP configuration on a Cisco router?
ITExamAnswers Editorial Team asked 6 years ago • ,
What is one reason to use the ip ospf priority command when the OSPF routing protocol is in use?
ITExamAnswers Editorial Team asked 6 years ago • ,
A network engineer examining the operation of EIGRP on a router notices that one particular route is in an active state. What can the engineer determine about this route?
ITExamAnswers Editorial Team asked 6 years ago • ,
What are the only two roles that permit an OSPF router to be configured for summarization? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • ,
Refer to the exhibit. Which two conclusions can be derived from the output? (Choose two.)
ITExamAnswers Editorial Team asked 6 years ago • ,
« Previous1…678910…133Next »
Ask Question

About The Author

ITExam Editorial Team

The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.