Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?
- The entire command, configure terminal, must be used.
- The administrator is already in global configuration mode.
- The administrator must first enter privileged EXEC mode before issuing the command.
- The administrator must connect via the console port to access global configuration mode.
Explanation: In order to enter global configuration mode, the command configure terminal, or a shortened version such as config t, must be entered from privileged EXEC mode. In this scenario the administrator is in user EXEC mode, as indicated by the > symbol after the hostname. The administrator would need to use the enable command to move into privileged EXEC mode before entering the configure terminal command.
Related exam: CCNA 1 v7 Checkpoint Exam: Basic Network Connectivity and Communications Exam Answers
Related exam: CCNA 1 v7 Course Final Exam Answers
Related exam: CCNA 1 (v5.1 + v6.0) Practice Final Exam Answers
Related exam: Introduction to Networks (Version 7.0) – ITNv7 Practice Final Exam
Related exam: Networking Essentials (Version 2) – Modules 17 – 20: Introduction to Cisco Networking Pre-Test Exam
Related exam: Networking Essentials 3.0 Checkpoint Exam: Configure Cisco Devices
Related exam: 18.4.2 Module 18 - The Cisco IOS Command Line Quiz
Related exam: CCNA 1 ITN (v5.0.3 + v6.0) Final Exam Answers
