Refer to the exhibit. R2 uses loopback0 interface 2.2.2.2 and R5 uses loopback0 interface 5.5.5.5 in the neighbor ip_address remote-as as_number statement in their respective configurations. A network administrator issues the show bgp ipv4 unicast summary command on R2. Which statement describes the adjacency state of R5?
ITExam Editorial Team
Last Updated: May 13, 2021
IT Exam Items Repository › Category: CCNP › Refer to the exhibit. R2 uses loopback0 interface 2.2.2.2 and R5 uses loopback0 interface 5.5.5.5 in the neighbor ip_address remote-as as_number statement in their respective configurations. A network administrator issues the show bgp ipv4 unicast summary command on R2. Which statement describes the adjacency state of R5?
Refer to the exhibit. R2 uses loopback0 interface 2.2.2.2 and R5 uses loopback0 interface 5.5.5.5 in the neighbor ip_address remote-as as_number statement in their respective configurations. A network administrator issues the show bgp ipv4 unicast summary command on R2. Which statement describes the adjacency state of R5?
- R2 uses the default route to reach R5.
- There is no route in the routing table of R2 to reach R5.
- An adjacency is formed between R2 and R5, but there is no message transmitted.
- An open message is sent to R5, but no response is received.
Explanation: If there is no route for the IP address or a router uses the default route to reach a neighbor, the state is Idle. If a route is found in the routing table and a three-way TCP handshake is complete, an open message is sent. If there is no response to the open message, the state is Active.
Related exam: CCNP ENARSI v8 Certification Practice Exam
About The Author
The ITExamAnswers Editorial Team is a dedicated group of certified IT professionals and network engineers. We rigorously review, verify, and update all exam materials to ensure you receive the most accurate and reliable resources for your certification journey.
