IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 1 v6
A client is downloading a large file from a server using FTP. One of the segments is lost during transit. What will happen?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
If a client sends an ISN of 2 to a server and a server responds with an ISN of 1 to the client, what is the final stage of the TCP three-way handshake?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which TCP header control bit is set on to terminate a TCP conversation?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What does UDP do when receiving messages that are more than one datagram in length?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Fill in the blank. A dynamic port in the range of 49152 to 65535 is also known as a(n) ____ port.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What range of ports can either be used by TCP to identify the requested service on the destination device or as a client source port?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is an advantage that UDP has over TCP?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Fill in the blank. Both TCP and UDP use ____ to separate multiple communications on the same channel.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which TCP header field specifies the number of segments that can be accepted before an acknowledgement is required?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which of the following types of applications would use UDP? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Fill in the blank. _____ is the term used to describe the interleaving of data from multiple users on the same network.
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
When using the netstat -r command on a host, you see a route 0.0.0.0 0.0.0.0.0. What does this route represent?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
The ip default-gateway command was not used when configuring a switch. How will this affect network communication? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What are the required steps for configuring an interface on a router? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
During the boot process of a Cisco router, you notice a series of hash symbols (#) appearing on the terminal emulator screen from the console session. In what phase is the boot process?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous123456…10Next »
Ask Question