Questions Bank

Filter:AllOpenResolvedClosedUnanswered
Which message is displayed when 10.10.10.1 is entered into the PC1 Web Browser address bar?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
23 views0 answers0 votes
A network administrator issues the show vlan brief command while troubleshooting a user support ticket. What output will be displayed?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
17 views0 answers0 votes
Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
18 views0 answers0 votes
Refer to the exhibit. A network administrator is configuring inter-VLAN routing on a network. For now, only one VLAN is being used, but more will be added soon. What is the missing parameter that is shown as the highlighted question mark in the graphic?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
25 views0 answers0 votes
Which two statements are correct with respect to SVI inter-VLAN routing? (Choose two.)
ResolvedCCNA v6 Labs asked 3 weeks ago • 
22 views0 answers0 votes
Which solution would help a college alleviate network congestion due to collisions?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
18 views0 answers0 votes
Refer to the exhibit. A network administrator has configured R1 as shown. When the administrator checks the status of the serial interface, the interface is shown as being administratively down. What additional command must be entered on the serial interface of R1 to bring the interface up?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
15 views0 answers0 votes
What is a characteristic of a routed port on a Layer 3 switch?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
15 views0 answers0 votes
Refer to the exhibit. A router-on-a-stick configuration was implemented for VLANs 15, 30, and 45, according to the show running-config command output. PCs on VLAN 45 that are using the 172.16.45.0 /24 network are having trouble connecting to PCs on VLAN 30 in the 172.16.30.0 /24 network. Which error is most likely causing this problem?​
ResolvedCCNA v6 Labs asked 3 weeks ago • 
19 views0 answers0 votes
Refer to the exhibit. A network administrator has configured router CiscoVille with the above commands to provide inter-VLAN routing. What type of port will be required on a switch that is connected to Gi0/0 on router CiscoVille to allow inter-VLAN routing?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
20 views0 answers0 votes
Refer to the exhibit. A network administrator is verifying the configuration of inter-VLAN routing. Users complain that PC2 cannot communicate with PC1. Based on the output, what is the possible cause of the problem?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
17 views0 answers0 votes
When routing a large number of VLANs, what are two disadvantages of using the router-on-a-stick inter-VLAN routing method rather than the multilayer switch inter-VLAN routing method? (Choose two.)
ResolvedCCNA v6 Labs asked 3 weeks ago • 
19 views0 answers0 votes
A high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
19 views0 answers0 votes
Refer to the exhibit. A network administrator has configured router CiscoVille with the above commands to provide inter-VLAN routing. What command will be required on a switch that is connected to the Gi0/0 interface on router CiscoVille to allow inter-VLAN routing?​
ResolvedCCNA v6 Labs asked 3 weeks ago • 
17 views0 answers0 votes
Refer to the exhibit. PC1 is unable to communicate with server 1. The network administrator issues the show interfaces trunk command to begin troubleshooting. What conclusion can be made based on the output of this command?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
21 views0 answers0 votes
Which four steps are needed to configure a voice VLAN on a switch port? (Choose four).
ResolvedCCNA v6 Labs asked 3 weeks ago • 
20 views0 answers0 votes
Refer to the exhibit. A technician is programming switch SW3 to manage voice and data traffic through port Fa0/20. What, if anything, is wrong with the configuration?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
17 views0 answers0 votes
Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
14 views0 answers0 votes
Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
21 views0 answers0 votes
Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?
ResolvedCCNA v6 Labs asked 3 weeks ago • 
15 views0 answers0 votes
123…65Next »
Ask Question