IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4.0 ESwitchingDrag the command on the left to the correct description on the right.ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhich term describes the time delay between a frame being sent from a source device and received on a destination device?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhat is the effect of entering the SW1(config-if)# duplex full command on a Fast Ethernet switch port?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhich two tasks does Auto-Negotiation in an Ethernet network accomplish? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhy should a default gateway be assigned to a switch?ITExamAnswers asked 9 months ago • CCNA 2 v5, CCNA 3 v4.0 ESwitchingThe network administrator wants to configure an IP address on a Cisco switch. How does the network administrator assign the IP address?ITExamAnswers asked 9 months ago • CCNA 2 v5, CCNA 3 v4.0 ESwitchingWhat are two key features of an Ethernet switch with Layer 2 capabilities? (Choose two.)ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingHow does the Ethernet switch process the incoming traffic using port-based memory buffering?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhich three statements are true about the Carrier Sense Multiple Access with Collision Detection (CSMA/CD) technology? (Choose three.)ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingDrag the term on the left to the appropriate description on the right.ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingRefer to the exhibit. How many collision and broadcast domains are presented in the network?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhat advantage does SSH offer over Telnet when remotely connecting to a device?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingWhat does pressing Ctrl-P on the command line do?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingRefer to the exhibit. What can be determined from the command output?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitchingRefer to the exhibit. An Ethernet switch has developed the MAC address table shown in the exhibit. What action will the switch take when it receives the frame shown at the bottom of the exhibit?ITExamAnswers asked 3 months ago • CCNA 3 v4.0 ESwitching