IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Refer to the exhibit. What is the purpose of this configuration?ITExamAnswers asked 11 months ago • CCNA Discovery v4, CCNP ROUTE v6.0A network administrator is determining which network address can be assigned to a new remote site with thirty-one users. The logical topology documentation is referenced and it is concluded that the 172.24.32.0/19 and 172.24.128.0/25 address blocks are available. Which network address could be assigned to the new remote site while wasting the fewest addresses?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Based on the show cdp neighbors detail command, which interface on Switch1 is connected to Router1?ITExamAnswers asked 7 months ago • CCNA Discovery v4A company has just transitioned from traditional telephony to an IP Telephony solution for their voice requirements. What statement describes a characteristic of the new system?ITExamAnswers asked 7 months ago • CCNA Discovery v4A school district decides to use the 172.30.0.0/16 network for its LAN networks. The network administrator must create an addressing scheme to support 500 users in the admin office, 200 at the high school, 60 at the elementary school and 28 at the district office. Which VLSM addressing scheme will correctly address the network with minimal waste?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is meant by “tunneling” in the context of migrating from IPv4 to IPv6?ITExamAnswers asked 7 months ago • CCNA Discovery v4What are two accurate descriptors of a DLCI? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The routers are configured with RIPv2 with default configurations. When attempting to communicate with other networks, hosts from 10.0.11.0/24 are experiencing connectivity issues. What could be done to resolve this issue?ITExamAnswers asked 7 months ago • CCNA Discovery v4During prototype testing, a LAN switch fails. As the switch re-initializes using the default parameters, a port that has a PC attached transitions to the forwarding state within one second. What protocol would support this feature?ITExamAnswers asked 7 months ago • CCNA Discovery v4What supports the ability of streaming video to be sent to a group of viewers simultaneously without congesting the entire network?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which protocol allows redundant Layer 2 links without switching loops?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. A network technician wishes to allow all traffic to internal LANs except traffic from network 10.0.0.0/10 that enters the router on its leased-line Internet connection. What will be apparent once these commands are entered into the router?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Before the encapsulation was changed to Frame Relay, the administrator verified physical connectivity by successfully pinging the remote router. After the encapsulation was changed, the administrator attempted to ping the remote router on the Frame Relay circuit but was not successful. A show frame-relay pvc command was issued. What could be the problem?ITExamAnswers asked 7 months ago • CCNA Discovery v4In configuring CHAP authentication for PPP, what is important to know about the format of usernames and passwords?ITExamAnswers asked 7 months ago • CCNA Discovery v4To reduce unwanted incoming traffic from the outside, a network technician is tasked with establishing the filtering rules for the network firewall. Which traffic should be allowed?ITExamAnswers asked 7 months ago • CCNA Discovery v4