IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Refer to the exhibit. Routers A, B, and C are part of the existing OSPF network. Router D has been added to the network. All routers are running OSPF and have the indicated priorities applied to the interface. What is the DR/BDR status immediately after router D is added to the existing network?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two statements describe the operation of link-state routing protocols? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The network administrator would like only the 172.16.32.0 network advertised to Router1. Which OSPF network command accomplishes this?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which statement is true regarding OSPF DR and BDR elections?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Which network statement configures the home router to allow all the interfaces to participate in OSPF?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Which commands configure router A for OSPF?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. A network administrator has implemented OSPF and the network has converged. If all router interfaces are enabled and functional, what route will OSPF view as lowest cost when moving frames from Host3 to Host1?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is always required for OSPF routers to share routing information?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. How was the OSPF default gateway entry for R2 determined?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two features are associated with Frame Relay OSPF point-to-multipoint environments? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What statement describes the DR/BDR relationship of the HQ router?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Which statement is true about the output from the show ip protocols command?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is the maximum number of hops that RIP will attempt before it considers the destination unreachable?ITExamAnswers asked 7 months ago • CCNA Discovery v4When should EIGRP automatic summarization be turned off?ITExamAnswers asked 4 years ago • CCNA, CCNA Discovery v4What two statements are correct regarding EIGRP authentication? (Choose two.)ITExamAnswers asked 4 years ago • CCNA Discovery v4