IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4During the boot process and assuming the default sequence, what is the second location where the router will look for the IOS?ITExamAnswers asked 7 months ago • CCNA Discovery v4Why is it difficult for network designers to predict the patterns and behavior of file transfer traffic?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Which two commands allow verification of end-to-end Layer 3 connectivity from R3 to all devices? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Company XYZ requires a WAN solution that provides flexible bandwidth options and supports one physical interface at the head office that would provide simultaneous connectivity to various remote sites. The distance from each site should not make the solution more expensive. Which WAN technology meets the requirements of the company?ITExamAnswers asked 7 months ago • CCNA Discovery v4What type of system connects to the PSTN and uses a PBX to route calls via analog or digital lines?ITExamAnswers asked 7 months ago • CCNA Discovery v4While configuring EIGRP on a router, the technician enters this command: Router(config-router)# variance 8 What is the effect of entering this command?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What can be determined about the connection between R3 and R4?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which statement describes the use of a network baseline?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. The routers are configured with RIPv2 and utilize the default configuration. When attempting to communicate with other networks, hosts from 172.31.1.0/24 are experiencing connectivity issues. What could be done to resolve this issue?ITExamAnswers asked 7 months ago • CCNA Discovery v4A network administrator has configured Frame Relay on a serial interface and issued the show interfaces serial command. The output shows that the interface is up and the line protocol is up. However, pings to the remote router across the link fail. What should the next step be to ensure that the IP address of the remote router appears in the Frame Relay map table of the local router?ITExamAnswers asked 7 months ago • CCNA Discovery v4A network designer has chosen to specify the use of a dedicated firewall appliance at the perimeter of a large network. Why would the designer use a dedicated firewall rather than using the Cisco IOS firewall feature set on the existing router?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which security procedure should be considered to protect a server farm against internal attacks?ITExamAnswers asked 7 months ago • CCNA Discovery v4What is a signaling standard that is used for managing and maintaining the connection between a CPE router and the service provider Frame Relay switch?ITExamAnswers asked 7 months ago • CCNA Discovery v4A network administrator is integrating IPv6 into an IPv4 network by encapsulating one protocol packet within another protocol. Which transition method is being used?ITExamAnswers asked 7 months ago • CCNA Discovery v4A network administrator is asked to upgrade the enterprise network devices and to modify the addressing scheme to support VLSM and route summarization. The current network infrastructure contains both Cisco and non-Cisco routers. The plan is to replace old routers gradually with the latest Cisco routers. Which two routing protocols can the administrator use to support both upgrading requirements? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4