IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Refer to the exhibit. The MAC address table is shown in its entirety. The Ethernet frame that is shown arrives at the switch. What two operations will the switch perform when it receives this frame? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. The default-information originate command is configured under the R1 OSPF configuration. After testing, workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet. Which action corrects the configuration issue?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What are two functions of a server on a network? (Choose two)
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is the primary function of a Layer 3 device?
IT Questions Bank 4IT Administrator asked 4 years ago • 
Refer to the exhibit. After the election process what is the root bridge in the HQ LAN?
IT Questions Bank 4IT Administrator asked 4 years ago • 
An engineer requires a scratch interface to actively attempt to establish a trunk link with a neighbor switch. What command must be configured?
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is a function of TFTP in network operations?
IT Questions Bank 4IT Administrator asked 4 years ago • 
What are two recommendations for protecting network ports from being exploited when located in an office space outside of an IT closet? (Choose two)
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is a recommended approach to avoid co-channel congestion while installing access points that use the 2.4 GHz frequency?
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is a function of a remote access VPN?
IT Questions Bank 4IT Administrator asked 4 years ago • 
Which CRUD operation modifies an existing table or view?
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is a DHCP client?
IT Questions Bank 4IT Administrator asked 4 years ago • 
What is the same for both copper and fiber interfaces when using SFP modules?
IT Questions Bank 4IT Administrator asked 4 years ago • 
When using Rapid PVST+, which command guarantees the switch is always the root bridge for VLAN 200?
IT Questions Bank 4IT Administrator asked 4 years ago • 
An engineer must configure Interswitch VLAN communication between a Cisco switch and a third-party switch. Which action should be taken?
IT Questions Bank 4IT Administrator asked 4 years ago • 
« Previous1…120121122123124…167Next »
Ask Question