IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNARefer to the exhibit. R1 is configured for static NAT. What IP address will Internet hosts use to reach PC1?ITExamAnswers asked 4 years ago • CCNAWhich QoS technique retains excess packets in a separate queue for later transmission?ITExamAnswers asked 4 years ago • CCNAIn NAT terms, what address type refers to the globally routable IPv4 address of a destination host on the Internet?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOpsWhich protocol or service uses UDP for a client-to-server communication and TCP for server-to-server communication?ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOpsWhat OSI physical layer term describes the physical medium which uses electrical pulses?Naura azzahra Nuraini fahur answered 55 years ago • CCNARefer to the exhibit. What solution can provide a VPN between site A and site B to support encapsulation of any Layer 3 protocol between the internal networks at each site?ITExamAnswers asked 4 years ago • CCNAIn which three ways is an IPv6 header simpler than an IPv4 header? (Choose three)ITExamAnswers asked 4 years ago • CCNAWhich two encoding methods are supported by REST APIs? (Choose two)ITExamAnswers asked 4 years ago • CCNAA technician is configuring a wireless network for a small business using a SOHO wireless router. Which two authentication methods are used, if the router is configured with WPA2? (Choose two.)IT Administrator asked 4 years ago • CCNAWhat are three responsibilities of the transport layer? (Choose three.)ITExamAnswers asked 4 years ago • CCNA, CCNA CyberOpsRefer to the exhibit. What is the effect of this configuration?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which switch in this configuration becomes the root bridge?ITExamAnswers asked 4 years ago • CCNARefer to Exhibit. An engineer is configuring the NEW York router to reach the Lot interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)ITExamAnswers asked 4 years ago • CCNAThe address pool of a DHCP server is configured with 172.23.143.0/26. The network administrator reserves 14 IP addresses for file servers. How many IP addresses are left in the pool to be assigned to other hosts?IT Administrator asked 4 years ago • CCNAThe address pool of a DHCP server is configured with 10.3.2.0/24. The network administrator reserves 3 IP addresses for printers. How many IP addresses are left in the pool to be assigned to other hosts?IT Administrator asked 4 years ago • CCNA