IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhat are two reasons to implement passive interfaces in the EIGRP configuration of a Cisco router? (Choose two.)ITExamAnswers asked 4 years ago • CCNAWhich model and which two characteristics would be more likely to be considered in purchasing an access layer switch, as compared to buying switches that operate at the other layers of the Cisco hierarchical design model? (Choose three.)ITExamAnswers asked 4 years ago • CCNAWhat two STP features are incorporated into Rapid PVST+? (Choose two.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. If the switch has been configured for PVST+ mode, what command output would replace the question marks?ITExamAnswers asked 4 years ago • CCNAMatch the step sequence to the multiarea OSPF route calculation process. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAMatch the switched LAN problem to the correct symptom. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAMatch the port state with its condition. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAWhich technological factor determines the impact of a failure domain?ITExamAnswers asked 4 years ago • CCNAWhich routing protocol is able to scale for large networks and utilizes non-backbone areas for expansion?ITExamAnswers asked 4 years ago • CCNAWhat are two reasons to install a single 48-port fixed configuration switch, rather than two 24-port fixed configuration switches, in a wiring closet that supports two classrooms? (Choose two.)ITExamAnswers asked 4 years ago • CCNAIn the Cisco hierarchical design model, which layer is more likely to have a fixed configuration switch than the other layers?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator is verifying the bridge ID and the status of this switch in the STP election. Which statement is correct based on the command output?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which switching technology would allow data to be transmitted over each access layer switch link and prevent the port from being blocked by spanning tree due to the redundant link?ITExamAnswers asked 4 years ago • CCNAIn wireless networks what is a disadvantage of using mixed mode on an AP?ITExamAnswers asked 4 years ago • CCNAWhen would a network engineer configure an access point with channel bonding?ITExamAnswers asked 4 years ago • CCNA