IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
What is the term used to describe a network topology where the subnets from a major classful network address space are separated from each other by addresses from a different major classful network address?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What type of packets are sent when there is a change in the EIGRP topology?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What capability do protocol-dependent modules provide to the EIGRP routing protocol?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which command will configure an IPv6 default static route?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What routing protocol can be configured to load balance across paths with unequal metrics through the use of the variance command?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What information is contained in OSPF type 3 LSAs?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two statements are correct about EIGRP acknowledgment packets? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which statement describes a characteristic of OSPF external routes?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
By default, how many equal cost routes to the same destination can be installed in the routing table of a Cisco router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which statement is true about the states of the IEEE 802.1D Spanning Tree Protocol?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator is configuring EIGRP load balancing with the commands: Router(config)# router eigrp 1 Router(config-router)# variance 3 Router(config-router)# end What is a direct result of entering these commands?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is a key distinction between classful and classless routing protocols?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What EIGRP packet type is used by EIGRP routers to discover neighbors on directly connected links?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which step can be taken to ensure that a switch added to the network does not overwrite the VLAN databases on existing switches in the same VTP domain?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…134135136137138…167Next »
Ask Question