IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Which action implements physical access control as part of the security program of an organization?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which plan must be Implemented to ensure optimal QoS marking practices on this network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. What is a reason for poor performance on the network interface?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is a function of an endpoint on a network?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
An engineer must configure R1 for a new user account. The account must meet these requirements: Which command must the engineer configure on the router?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which next-hop IP address does Routed use for packets destined to host 10.10.13.158?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. An IP subnet must be configured on each router that provides enough addresses for the number of assigned hosts and anticipates no more than 10% growth for now hosts. Which configuration script must be used?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A network engineer must implement an IPv6 configuration on the vlan 2000 interface to create a routable locally-unique unicast address that is blocked from being advertised to the internet. Which configuration must the engineer apply?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Site A was recently connected to site B over a new single-mode fiber path. Users at site A report Intermittent connectivity Issues with applications hosted at site B. What is the reason for the problem?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
A Cisco engineer must configure a single switch interface to meet these requirements: Which command set must the engineer apply?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Router R1 resides in OSPF Area 0. After updating the R1 configuration to influence the paths that it will use to direct traffic, an engineer verified that each of the four Gigabit interfaces has the same route to 10.10.0.0/16. Which interface will R1 choose to send traffic to reach the route?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Which configuration enables DHCP addressing for hosts connected to interface FastEthernet0/1 on router R4?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. An engineer is updating the R1 configuration to connect a new server to the management network. The PCs on the management network must be blocked from pinging the default gateway of the new server. Which command must be configured on R1 to complete the task?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
R1 as an NTP server must have: * NTP authentication enabled * NTP packets sourced from Interface loopback 0 * NTP stratum 2 * NTP packets only permitted to client IP 209.165 200 225 How should R1 be configured?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Refer to the exhibit. Web traffic is coming in from the WAN interface. Which route takes precedence when the router is processing traffic destined for the LAN network at 10.0.10.0/24?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…6263646566…167Next »
Ask Question