IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
Which method allows a computer to react accordingly when it requests data from a server and the server takes too long to respond?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Match each characteristic to its corresponding Internet connectivity type. (Not all options are used.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. A network administrator has configured a standard ACL to permit only the two LAN networks attached to R1 to access the network that connects to R2 G0/1 interface, but not the G0/0 interface. When following the best practices, in what location should the standard ACL be applied?
IT Questions Bank 4IT Administrator asked 4 years ago • 
Refer to the exhibit. Which route does R1 select for traffic that is destined to 192 168.16.2?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Which two statements about the interface that generated the output are true? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. With which metric was the route to host 172.16.0.202 learned?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. Which type of configuration is represented in the output?
IT Questions Bank 8Giuseppe Gaviano commented 3 years ago • 
Which Cisco solution helps prevent ARP spoofing and ARP poisoning attacks?
IT Questions Bank 4IT Administrator asked 4 years ago • ,
Refer to the exhibit. An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:”% Connection refused by remote host” Without allowing Telnet access from PC-1, which action must be taken to permit the traffic?
IT Questions Bank 10Juan Rodriguez commented 3 years ago • 
An ACL is applied inbound on a router interface. The ACL consists of a single entry: access-list 101 permit udp 192.168.100.0 0.0.2.255 64.100.40.0 0.0.0.15 eq telnet . If a packet with a source address of 192.168.101.45, a destination address of 64.100.40.4, and a protocol of 23 is received on the interface, is the packet permitted or denied?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What three requirements are defined by the protocols used in network communcations to allow message transmission across a network? (Choose three.)
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What type of delivery uses data link layer addresses?
IT Questions Bank 4IT Administrator asked 3 years ago • 
What layer of the TCP/IP protocol model determines the best path through the network?
IT Questions Bank 4IT Administrator asked 3 years ago • 
Which statement describes a characteristic of the frame header fields of the data link layer?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which two factors influence the method that is used for media access control? (Choose two.)
IT Questions Bank 4IT Administrator asked 3 years ago • 
« Previous1…8990919293…167Next »
Ask Question