IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it Which protocol can provide error correction for data that is transmitted over a Frame Relay link?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANWhat is an advantage of configuring subinterfaces in a Frame Relay environment?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANWhich situation favors a multipoint topology over point-to-point?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANRefer to the exhibit. What is placed in the Address field of a frame that will travel from the Orlando office to the DC office?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWAN, CCNA Discovery v4What reliability advantage does Frame Relay offer over leased lines?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANMatch the status of a DLCI from the show frame-relay pvc command with its meaning.ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWANWhat are two reasons Frame Relay is more cost-effective than leased lines? (Choose two.)ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWANWhich statement accurately describes the split-horizon problem with regard to a multipoint topology?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANWhy are Frame Relay paths referred to as virtual?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWAN, CCNA Discovery v4What is used to identify the path to the next Frame Relay switch in a Frame Relay network?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWAN, CCNA Discovery v4Drag the description on the left to the appropriate protocol on the right. Not all options are used.ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWANMatch each characteristic on the left with the appropriate authentication protocol on the right.ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWANWhat is required to successfully establish a connection between two routers using CHAP authentication?ITExamAnswers asked 10 months ago • CCNA 4 v4.0 EWANThe network administrator is configuring Router1 to connect to Router2 using a three-way handshake authentication. Drag the commands necessary to configure Router1 from the left to the appropriate description on the right. Not all options are used.ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWANA technician testing functionality of a recently installed router is unable to ping the serial interface of a remote router. The technician executes the show interface serial0/0 command on the local router and sees the following line in the router: Serial0/0 is down, line protocol is down What are two possible causes for this command output? (Choose two.)ITExamAnswers asked 4 months ago • CCNA 4 v4.0 EWAN