IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it Select the VLSM subnets of the 172.16.0.0 network that will simultaneously provide the total number of required hosts on each subnet? Match the subnet with the number of required hosts by dragging the options on the left to the targets on the right. Not all options are used.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhen using a classful class A IP address scheme, how many octects are used to designate the network portion of the address?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhich of the following identify the most efficient use for each of these masks? (Choose three.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat two methods were used to allow the continued use of IPv4 addressing once the available hosts were exhausted? (Choose two).ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingDrag the description on the left to the appropriate term on the right. (Not all options are used.)ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingDivide the items on the left into the targets on the right determining support for VLSM.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingTo ensure proper routing in a network, the network administrator should always check the router configuration to verify that appropriate routes are available. The commands on the left will allow the network administrator to view the router configuration for the information needed. Drag each command to its result.ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat is the purpose of the network command when RIP is being configured as the routing protocol?ITExamAnswers asked 9 months ago • CCNA 2 v4.0 ERouting, CCNA Discovery v4Refer to the exhibit. What is the administrative distance of the route to the 192.168.5.0 network?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingHow does a router running RIPv1 determine the subnet mask of the routes that are received in routing updates?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingRefer to the exhibit. All routers are running RIPv1. The interfaces on all routers are up and stable. Users on the 10.16.1.0 network cannot access services on the 10.16.1.64 network. What is the cause of this problem?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat command will create a candidate default route on a RIP router?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat command is used with RIP to propagate default routes to neighbors?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat makes a router a boundary router in RIP?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERoutingWhat problem does the command passive-interface help resolve?ITExamAnswers asked 5 months ago • CCNA 2 v4.0 ERouting