IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

Pages 1

Refer to the exhibit. What command was used on Router1 to produce the output shown in the graphic?
Pages 2ITExamAnswers asked 5 months ago • 
Refer to the exhibit. The network administrator must remove the route to the 10.0.0.0 network. What command will accomplish this task?
Pages 2ITExamAnswers asked 5 months ago • 
Which statement is true concerning configuring static routes using next-hop addresses?
Pages 2ITExamAnswers asked 10 months ago • ,
Refer to the exhibit. Which two commands must be configured to allow communication between the 192.168.1.0/24 and 10.0.0.0/8 networks? (Choose two.)
Pages 2ITExamAnswers asked 5 months ago • 
The network administrator configured the ip route 0.0.0.0 0.0.0.0 serial 0/0 command on the router. How will this command appear in the routing table assuming the serial0/0 interface is up?
Pages 2ITExamAnswers asked 5 months ago • 
Refer to the exhibit. Which port is used to connect a router to a LAN switch?
Pages 2ITExamAnswers asked 5 months ago • 
Which statement is true regarding metrics used by routing protocols?
Pages 2ITExamAnswers asked 5 months ago • 
What two statements are correct regarding how a router forwards packets? (Choose two.)
Pages 2ITExamAnswers asked 5 months ago • 
A network engineer is configuring a new router. The interfaces have been configured with IP addresses but no routing protocols or static routes have been configured yet. What routes are present in the routing table?
Pages 2ITExamAnswers asked 5 months ago • 
What two tasks do dynamic routing protocols perform? (Choose two.)
Pages 2ITExamAnswers asked 4 years ago • , , ,
Which routing principle is correct?
Pages 2ITExamAnswers asked 5 months ago • 
Which of the following commands will set the privileged mode password to “quiz”?
Pages 2ITExamAnswers asked 5 months ago • 
Which two commands can a technician use to determine if router serial ports have IP addresses that are assigned to them? (Choose two.)
Pages 2ITExamAnswers asked 5 months ago • 
Construct the sequence of events that occurs during the router startup process. (Not all options apply.)
Pages 2ITExamAnswers asked 5 months ago • 
Which of the following matches a router component with its function?
Pages 2ITExamAnswers asked 5 months ago • 
« Previous1…2930313233…1,321Next »
Ask Question