IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4Refer to the exhibit. All routers are properly configured with default configurations and are running the OSPF routing protocol. The network is fully converged. A host on the 192.168.3.0/24 network is communicating with a host on the 192.168.2.0/24 network. Which path will be used to transmit the data?ITExamAnswers asked 2 years ago • CCNA 2 v4What is the key responsibility of the switching function within a router?ITExamAnswers asked 2 years ago • CCNA 2 v4Which statement is true about the metrics used by routing protocols?ITExamAnswers asked 2 years ago • CCNA 2 v4In a lab test environment, a router has learned about network 172.16.1.0 through four different dynamic routing processes. Which route will be used to reach this network?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Two connected routers are unable to establish adjacency. Based on the show ip ospf interface output, what could be the problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Which feature of RIPv2 enables it to function as a classless routing protocol?ITExamAnswers asked 2 years ago • CCNA 2 v4A network administrator is in charge of two separate networks that share a single building. What device will be required to connect the two networks and add a common connection to the Internet that can be shared?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Which two interface variables will determine the metric that is used on EIGRP routes? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Two routers need to be configured within a single OSPF area. Which two components need to be configured on both routers to achieve this? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The hosts that are connected to R2 are unable to ping the hosts that are connected to R1. How can this problem be resolved?ITExamAnswers asked 2 years ago • CCNA 2 v4A router has learned two equal cost paths to a remote network via the EIGRP and RIP protocols. Both protocols are using their default configurations. Which path to the remote network will be installed in the routing table?ITExamAnswers asked 2 years ago • CCNA 2 v4Which routing protocol maintains a topology table separate from the routing table?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. A network administrator configures a static route on router R1 to reach the 192.168.1.0/24 network. Which IP address should be used as the next-hop address in the ip route command?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. If the attached device is configured correctly, what action can be taken to change the state of FastEthernet0/0 to Up Up?ITExamAnswers asked 2 years ago • CCNA 2 v4Which two technologies can be used in distance vector routing protocols to prevent routing loops? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4