IT Questions Bank

Mar 16, 2020 Last Updated: Apr 13, 2022 No Comments
Tweet Share Pin it



IT Questions Bank › Category: CCNA 2 v4
What are two functions of a router? (Choose two.)
ITExamAnswers asked 3 years ago • , , , , , ,
Which two statements are true regarding classless routing protocols? (Choose two.)
ITExamAnswers asked 3 years ago • , ,
Which two statements correctly describe the concepts of administrative distance and metric? (Choose two.)
ITExamAnswers asked 3 years ago • , ,
A router has EIGRP configured as the only routing protocol. In what way might EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. A network administrator is accessing router R1 from the console port. Once the administrator is connected to the router, which password should the administrator enter at the R1> prompt to access the privileged EXEC mode?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. All routers are running the same routing protocol. Based on the exhibit and its displayed commands, which statement is true?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. The output of the show ip route command for router R1 is displayed. What action will the router take for a packet that is destined for 192.168.1.5?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. Which two components are required to complete the configuration? (Choose two.)
ITExamAnswers asked 2 months ago • 
A network administrator uses the RIP routing protocol to implement routing within an autonomous system. What are two characteristics of this protocol? (Choose two.)
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. All routers are properly configured to use the EIGRP routing protocol with default settings, and the network is fully converged. Which statement correctly describes the path that the traffic will use from the 10.1.1.0/24 network to the 10.1.2.0/24 network?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. R2 is configured correctly. The network administrator has configured R1 as shown. Which two facts can be deduced from the configuration of R1? (Choose two.)
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. Both routers are using the RIP protocol. Devices on the 192.168.1.1 network can ping the S0/0/0 interface on R2 but cannot ping devices on the 192.168.2.1 network. What is a possible cause of this problem?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. All interfaces are addressed and functioning correctly. The network administrator runs the tracert command on host A. Which two facts could be responsible for the output of this command? (Choose two.)
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. The routers are properly configured using a dynamic routing protocol with default settings, and the network is fully converged. Router A is forwarding data to router E. Which statement is true about the routing path?
ITExamAnswers asked 2 months ago • 
Refer to the exhibit. The show cdp neighbors command was run at R1. Which two facts about the newly detected device can be determined from the output? (Choose two.)
ITExamAnswers asked 2 months ago • 
123…30Next »
Ask Question