IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 2 v4A static route that points to the next hop IP will have what administrative distance and metric in the routing table?ITExamAnswers asked 2 years ago • CCNA 2 v4If a router cannot find a valid configuration file during the startup sequence, what will occur?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The network administrator has configured the router with the interface IP addresses shown for the directly connected networks. Pings from the router to hosts on the connected networks or pings between router interfaces are not working. What is the most likely problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What can be concluded from the routing table output in the exhibit? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. The frame shown in the exhibit was received by the router. The router interfaces are operational. How will the router process this frame? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. After host 2 is connected to the switch on the LAN, host 2 is unable to communicate with host 1. What is the cause of this problem?ITExamAnswers asked 2 years ago • CCNA 2 v4Which are functions of a router? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. All routers have a route in its routing table to each network that is shown in the exhibit. Default routes have not been issued on these routers. What can be concluded about how packets are forwarded in this network? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. What can be concluded from the output of the running-configuration of a router?ITExamAnswers asked 2 years ago • CCNA 2 v4Refer to the exhibit. Host A pings host B. When R4 accepts the ping into the Ethernet interface, what two pieces of header information are included? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 2 v4What is the outcome of entering these commands?ITExamAnswers asked 2 years ago • CCNA 2 v4Which of the following is the correct flow of routines for a router startup?ITExamAnswers asked 2 years ago • CCNA 2 v4What three processes does a router execute when it receives a packet from one network that is destined for another network? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4The network administrator needs to connect two routers directly via their FastEthernet ports. What cable should the network administrator use?ITExamAnswers asked 2 years ago • CCNA 2 v4What information about the router and its startup process can be gathered from the output of the show version command? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 2 v4