IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4A network technician is asked to examine an existing switched network. Following this examination, the technician makes recommendations for adding new switches where needed and replacing existing equipment that hampers performance. The technician is given a budget and asked to proceed. Which two pieces of information would be helpful in determining necessary port density for new switches? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which two features are supported at all three levels of the Cisco three-layer hierarchical model? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Which layer of the OSI model does an access layer LAN switch use to make a forwarding decision?ITExamAnswers asked 2 years ago • CCNA 3 v4Configuring communication between devices on different VLANs requires the use of which layer of the OSI model?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Beginning with HR servers and workstations, a network engineer is designing a new security structure for the network. Which set of policies adheres to the hierarchical network model design principles?ITExamAnswers asked 2 years ago • CCNA 3 v4What is the likely impact of moving a conventional company architecture to a completely converged network?ITExamAnswers asked 2 years ago • CCNA 3 v4Which hierarchical design model layer controls the flow of network traffic using policies and delineates broadcast domains by performing routing functions between virtual LANs (VLANs)?ITExamAnswers asked 2 years ago • CCNA 3 v4Which feature supports higher throughput in switched networks by combining multiple switch ports?ITExamAnswers asked 2 years ago • CCNA 3 v4Which two characteristics are associated with enterprise level switches? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. What characteristic of hierarchical network designs is exhibited by having SW3 connected to both SW1 and Sw2?ITExamAnswers asked 2 years ago • CCNA 3 v4