IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v4Which two statements about Layer 2 Ethernet switches are true? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The exhibit shows partial output of the show running-config command. The enable password on this switch is “cisco.” What can be determined from the output shown?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. The switch and workstation are administratively configured for full-duplex operation. Which statement accurately reflects the operation of this link?ITExamAnswers asked 2 years ago • CCNA 3 v4, Network FundamentalsWhen a switch receives a frame and the source MAC address is not found in the switching table, what action will be taken by the switch to process the incoming frame?ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator uses the CLI to enter a command that requires several parameters. The switch responds with “% Incomplete command”. The administrator cannot remember the missing parameters. What can the administrator do to get the parameter information?ITExamAnswers asked 2 years ago • CCNA 3 v4Which command line interface (CLI) mode allows users to configure switch parameters, such as the hostname and password?ITExamAnswers asked 2 years ago • CCNA 3 v4Refer to the exhibit. Which hosts will receive a broadcast frame sent from Host A?ITExamAnswers asked 2 years ago • CCNA 3 v4Which layer of the hierarchical network design model is refered to as the high-speed backbone of the internetwork, where high availability and redundancy are critical?ITExamAnswers asked 2 years ago • CCNA 3 v4A technician is attempting to explain Cisco StackWise technology to a client that is setting up three stackable switches. Which explanation accurately describes StackWise technology?ITExamAnswers asked 2 years ago • CCNA 3 v4What statement best describes a modular switch?ITExamAnswers asked 2 years ago • CCNA 3 v4Link aggregation should be implemented at which layer of the hierarchical network?ITExamAnswers asked 2 years ago • CCNA 3 v4A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v4For organizations that are implementing a voice over IP solution, what functionality should be enabled at all three layers of the hierarchical network?ITExamAnswers asked 2 years ago • CCNA 3 v4At which heirarchical layer are switches normally not required to process all ports at wire speed?ITExamAnswers asked 2 years ago • CCNA 3 v4Which hierarchical design characteristic would be recommended at both the core and distribution layers to protect the network in the case of a route failure?ITExamAnswers asked 2 years ago • CCNA 3 v4