IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v7A network administrator configures the border router with the ip nat inside source list 4 pool NAT-POOL global configuration command. What is required to be configured in order for this particular command to be functional?ITExamAnswers asked 2 years ago • CCNA 3 v7When NAT is used in a small office, which address type or types are typically used for hosts on the local LAN?ITExamAnswers asked 2 years ago • CCNA 3 v7What does the CLI prompt change to after you enter the command ip access-list extended AAAFILTER in global configuration mode?ITExamAnswers asked 2 years ago • CCNA 3 v7What effect does the permit tcp 10.10.100 0.0.0.255 any eq www extended named ACE have when implemented inbound on a G0/0 interface?ITExamAnswers asked 2 years ago • CCNA 3 v7You create a standard ACL called PERMIT-VTY to permit only an administrative host vty access to the router. Which line configuration command would correctly apply this ACL to the vty lines?ITExamAnswers asked 2 years ago • CCNA 3 v7In the following example, you forgot to enter an ACE to deny the user at IP address 192.168.10.10. Which command would correctly enter the ACE to filter this address?ITExamAnswers asked 2 years ago • CCNA 3 v7A network administrator is writing a standard ACL to deny any traffic from the 10.10.0.0/16 network but permit all other traffic. Which two commands should be used? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7A network administrator needs to configure a standard ACL so that only the workstation of the administrator with the IP address 10.1.1.10 can access the virtual terminal of the main router. Which two configuration commands can achieve the task? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7In the second ACE shown in the following example, port 400 was incorrectly specified instead of port 443. What is the best way to correct this error?ITExamAnswers asked 2 years ago • CCNA 3 v7Which two packet filters could a network administrator use on an IPv4 extended ACL? (Choose two.)ITExamAnswers asked 4 years ago • CCNA 3 v7Consider the following output for an ACL that has been applied to a router via the access-class in command. What can a network administrator determine from the output that is shown?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v7What wildcard mask will match network 10.10.100.64/26?ITExamAnswers asked 2 years ago • CCNA 3 v7Which statement describes a characteristic of standard IPv4 ACLs?ITExamAnswers asked 4 years ago • CCNA 3 v7What type of ACL offers increased flexibility and control over network traffic?ITExamAnswers asked 2 years ago • CCNA 3 v7What wildcard mask will match networks 10.16.0.0 through 10.19.0.0?ITExamAnswers asked 2 years ago • CCNA 3 v7