IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA 3 v7
A user receives a call from someone in IT services, asking her to confirm her username and password for auditing purposes. Which security threat does this represent?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What is Trojan horse malware?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which type of hacker is motivated by protesting political and social issues?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What commonly motivates cybercriminals to attack networks as compared to hacktivists or statesponsored hackers?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which network security statement is true?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which of these factors will prevent two routers from forming an OSPFv2 adjacency? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
An administrator is configuring single-area OSPF on a router. One of the networks that must be advertised is 64.100.1.64 255.255.255.192. Which OSPF network statement should be configured?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
By default, what is the OSPF cost for a link with Gigabit Ethernet interfaces?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
An OSPF router has three directly connected networks; 10.1.0.0/16, 10.1.1.0/16, and 10.1.2.0/16. Which OSPF network command would advertise only the 10.1.1.0 network to neighbors?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Which of the following will OSPF use when it chooses its router ID?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
What indicates to a link-state router that a neighbor is unreachable?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the default router priority value for all Cisco OSPF routers?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
To establish a neighbor adjacency, two OSPF routers exchange Hello packets. Which values in the Hello packets must match on the two routers? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
You are troubleshooting convergence and adjacency issues in an OSPFv2 network and have noticed that network route entries are missing from the routing table. Which commands provide additional information about the state of router adjacencies, timer intervals, and the area ID? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
Two OSPFv2 routers are interconnected using a point-to-point WAN link.Which command could be used to verify the configured Hello and Dead timer intervals?
IT Questions Bank 2ITExamAnswers asked 2 years ago • 
« Previous1…1011121314…30Next »
Ask Question