IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 3 v7Which command is used to verify the OSPFv2 router ID, the interfaces explicitly configured to advertise OSPF routes, the passive interfaces, the neighbors the router is receiving updates from, and the default administrative distance, which is 110 for OSPF?ITExamAnswers asked 2 years ago • CCNA 3 v7A router is participating in an OSPFv2 domain. What will always happen if the Dead interval expires before the router receives a Hello packet from an adjacent OSPF router? has a default static route that has been configured via the interface that connects to the ISP. Which command would the network administrator apply on this router so that other routers in the OSPF network will use this default route?ITExamAnswers asked 2 years ago • CCNA 3 v7When an OSPF network is converged and no network topology change has been detected by a router, how often are LSU packets sent to neighboring routers?ITExamAnswers asked 2 years ago • CCNA 3 v7In an OSPF network when are DR and BDR elections required?ITExamAnswers asked 4 years ago • CCNA 3 v7Which OSPF states are performed prior to two routers forming a neighbor adjacency? (Choose three.)ITExamAnswers asked 2 years ago • CCNA 3 v7Which type of OSPFv2 packet contains an abbreviated list of the LSDB of a sending router and is used by receiving routers to check against the local LSDB?ITExamAnswers asked 4 years ago • CCNA, CCNA 3 v7Which step does an OSPF-enabled router take immediately after the OSPF router builds the topology table?ITExamAnswers asked 2 years ago • CCNA 3 v7Which of the following facilitates hierarchical routing in OSPF?ITExamAnswers asked 2 years ago • CCNA 3 v7What are the advantages of using multiarea OSPF? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7What are the purposes of an OSPF router ID? (Choose two.)ITExamAnswers asked 2 years ago • CCNA 3 v7Which OSPF data structure is identical in all routers in an OSPF area after convergence?ITExamAnswers asked 2 years ago • CCNA 3 v7True or False: The underlay limits the number of devices the network administrator must program. It also provides services and alternative forwarding methods not controlled by the underlying physical devices.ITExamAnswers asked 2 years ago • CCNA 3 v7Which IBN feature installs policies that capture intent into the physical and virtual network infrastructure using networkwide automation?ITExamAnswers asked 2 years ago • CCNA 3 v7Which IBN feature enables the network administrator to express the expected networking behavior that will best support the business intent?ITExamAnswers asked 2 years ago • CCNA 3 v7Which IBN feature is responsible for continuous validation and verification that the network is meeting the expressed intent?ITExamAnswers asked 2 years ago • CCNA 3 v7