IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA 4 v4.0 EWANList and explain the anatomy of a worm attack and the four steps to mitigate it.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANList three types of DoS attacks and three types of DDoS attacks.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANList four types of access attacks.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANList the four types of reconnaissance attacks, and provide an example of a tool that can be used to carry out each type of attack.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANMatch the network management service with its description:ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANWhich services should be disabled if they aren’t required on a router to prevent security vulnerabilities? (Choose three.)ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANWhat are the three required steps to configure SDM?ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANMatch each network policy with its description:ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANMatch each attack type with its description:ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANA technician has been asked to perform a Cisco SDM one-step lockdown test. Which mode and SDM page should be used to initiate the test?ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANWhich pieces of information can you determine from opening a router’s Cisco SDM home page? (Choose two.)ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANMatch a security category to each security weakness (answers may be used more than once):ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANRefer to the exhibit and the following configuration. R1 cannot establish connectivity with the routers over the Frame Relay cloud. What are the problems with this configuration?ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANCompare and contrast the following terms: access rate, CIR, CBIR, and BE.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWANRefer to the exhibit. The following configuration is for router R1: interface s0/0/1 ip address 10.1.1.1 255.255.255.252 encapsulation frame-relay bandwidth 64 What command on R1 is required to statically configure a Frame Relay connection to R2? Traffic between sites must also support OSPF.ITExamAnswers asked 9 months ago • CCNA 4 v4.0 EWAN