Refer to the exhibit. The following configuration is for router R1: interface s0/0/1 ip address 10.1.1.1 255.255.255.252 encapsulation frame-relay bandwidth 64 What command on R1 is required to statically configure a Frame Relay connection to R2? Traffic between sites must also support OSPF.

IT Questions Bank › Category: CCNA 4 v4.0 EWAN › Refer to the exhibit. The following configuration is for router R1: interface s0/0/1 ip address 10.1.1.1 255.255.255.252 encapsulation frame-relay bandwidth 64 What command on R1 is required to statically configure a Frame Relay connection to R2? Traffic between sites must also support OSPF.

Refer to the exhibit.

The following configuration is for router R1:

interface s0/0/1
ip address 10.1.1.1 255.255.255.252
encapsulation frame-relay
bandwidth 64

What command on R1 is required to statically configure a Frame Relay connection to R2? Traffic between sites must also support OSPF.

frame-relay map ip 10.1.1.2 102 broadcast

Exam with this question: EWAN v4 Chapter 3 Check Your Understanding: Frame Relay