IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4Refer to the exhibit. The switches in the exhibit are connected with trunks within the same VTP management domain. Each switch is labeled with its VTP mode. A new VLAN is added to Switch3. This VLAN does not show up on the other switches. What is the reason for this?ITExamAnswers asked 2 years ago • CCNA 3 v4, CCNA Discovery v4Which three must be used when a router interface is configured for VLAN trunking? (Choose three.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. Switch1 is not participating in the VTP management process with the other switches. Which two are possible reasons for this? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4When are MAC addresses removed from the CAM table?ITExamAnswers asked 7 months ago • CCNA Discovery v4A router has two serial interfaces and two Fast Ethernet interfaces. This router must be connected to a WAN link and to a switch that supports four VLANs. How can this be accomplished in the most efficient and cost-effective manner to support inter-VLAN routing between the four VLANs?ITExamAnswers asked 7 months ago • CCNA Discovery v4The information contained in a BPDU is used for which two purposes? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4A router is configured to connect to a trunked uplink as shown in the exhibit. A packet is received on the FastEthernet 0/1 physical interface from VLAN 10. The packet destination address is 192.168.1.120. What will the router do with this packet?ITExamAnswers asked 7 months ago • CCNA Discovery v4Refer to the exhibit. What two statements can be concluded from the information that is shown in the exhibit? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4What is the maximum recommended cable length for Fast Ethernet over UTP?ITExamAnswers asked 7 months ago • CCNA Discovery v4A network administrator has just inserted a new WIC2T controller into the first available slot of an 1841 router. The administrator needs to configure the first serial interface of this new controller. Which interface should be used?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two items protect a corporate network against malicious attacks at the enterprise edge ? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4What device is responsible for moving packets to destination networks outside the local network?ITExamAnswers asked 7 months ago • CCNA Discovery v4A Cisco router needs to be configured from a remote location by the use of out-of-band management. Which method should be used?ITExamAnswers asked 7 months ago • CCNA Discovery v4Which two pieces of information are documented in a logical topology map? (Choose two.)ITExamAnswers asked 7 months ago • CCNA Discovery v4Which type of network map shows the location of hosts, network devices, and media?ITExamAnswers asked 7 months ago • CCNA Discovery v4