IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA Discovery v4
A network designer needs to determine if a proposed IP addressing scheme allows efficient route summarization and provides the appropriate amount of scalability to a design. What is useful for validating a proposed hierarchical IP addressing scheme?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Refer to the exhibit. The redundant paths are of equal bandwidth and EIGRP is the routing protocol in use. Which statement describes the data flow from Server to PC2?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Switch port Fa0/24 was previously configured as a trunk, but now it is to be used to connect a host to the network. How should the network administrator reconfigure switch port Fa0/24?
IT Questions Bank 4IT Administrator asked 3 years ago • ,
Refer to the exhibit. During prototype testing, verification of VLAN connectivity is being performed. Based on the information shown, what command produced the output?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
What Rapid Spanning Tree Protocol (RSTP) state is given to the forwarding port elected for every switched Ethernet LAN segment?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Refer to the exhibit. During prototyping, Layer 2 functionality is being tested. Based on the output shown, which two pieces of information can be determined? (Choose two.)
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Refer to the exhibit. During prototype testing of the Cisco network shown, connectivity must be verified. Assuming all connections are working and CDP is enabled on all devices and interfaces, on which device was the command issued?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
How do designers decide which network functions need to be included in the prototype test?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
What OSI model Layer 2 security measure can a network engineer implement when prototyping network security?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Refer to the exhibit. A network designer creates a test plan that includes the specification shown. In which section of the test plan would this specification be found?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
While preparing a network test plan document, a network designer records all initial and modified device configurations. Which section of the document typically contains this information?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
A network engineer has decided to pilot test a portion of a new network design rather than rely on a prototype for proof-of-concept. What are two advantages of pilot testing a design concept?(Choose two.)
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
Which network configuration would require the use of the no auto-summary command?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
With RIPv2, what should be done to avoid routing problems if a discontiguous network exists?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
What is a characteristic of IPv6?
IT Questions Bank 2ITExamAnswers asked 8 months ago • 
« Previous1…7475767778…86Next »
Ask Question