IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNA Discovery v4How would the routes for networks 172.16.1.0/24, 172.16.3.0/24, and 172.16.15.0/24 be summarized?ITExamAnswers asked 8 months ago • CCNA Discovery v4A network designer is implementing a new network for a company. The designer is using all new Cisco equipment and has decided to select a hierarchical routing protocol for the network. The designer wishes to minimize traffic from routing updates but also needs fast routing convergence in the event of a topology change. Also, the existing IP addressing scheme requires that the selected protocol support VLSM. Which routing protocol should be chosen?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which subnet will provide sufficient addresses for the Production network with minimal waste?ITExamAnswers asked 8 months ago • CCNA Discovery v4Which two are best practices for creating a new IP addressing scheme for a network? (Choose two.)ITExamAnswers asked 8 months ago • CCNA Discovery v4Which range includes all available networks in the 192.168.8.0/21 network?ITExamAnswers asked 8 months ago • CCNA Discovery v4An administrator is configuring IPv6 on a router. The steps that have already been completed are: What is the remaining step to complete the activation of RIPng?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The IT management is adding three VLANs to the wgroup3 switch. The current subnet will be broken down to support 14 hosts for each of the new VLANs. What will the new subnet mask be for these VLANs?ITExamAnswers asked 8 months ago • CCNA Discovery v4Which statement describes MD5 authentication for neighbor authentication?ITExamAnswers asked 8 months ago • CCNA Discovery v4A network administrator is asked to design a new addressing scheme for a corporate network. Presently, there are 850 users at the head office, 220 users at sales, 425 at manufacturing, and 50 at the research site. Which statement defines the correct VLSM addressing map with minimal waste using the 172.17.0.0/16 network?ITExamAnswers asked 8 months ago • CCNA Discovery v4What is a good design practice when developing a hierarchical addressing scheme?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. Which set of router commands is required to turn on unequal-cost load sharing so that RTRA selects the path A-B-E and the lowest cost path A-C-E to the Internet?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. What is the first usable IP address that can be assigned to the WGROUP3 switch?ITExamAnswers asked 8 months ago • CCNA Discovery v4Refer to the exhibit. The IT management has determined that the new subnet for WGROUP3 needs to be broken down into four more subnets. What would the subnet mask be for the four newly created subnets within WGROUP3?ITExamAnswers asked 8 months ago • CCNA Discovery v4After activating IPv6 traffic forwarding, configuring IPv6 addresses, and globally configure RIPng, what is the remaining step to activate RIPng?ITExamAnswers asked 8 months ago • CCNA Discovery v4How many bits make up an IPv6 address?ITExamAnswers asked 8 months ago • CCNA Discovery v4