IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
A user is reading a book from the website https://www.books-info.com/author1a/book2.html#page100 . Which part of the web link is called a fragment?
IT Questions Bank 2IT Administrator asked 4 years ago • 
A network administrator is troubleshooting the dynamic NAT that is configured on router R2. Which command can the administrator use to see the total number of active NAT translations and the number of addresses that are allocated from the NAT pool?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which three traffic-related factors would influence selecting a particular WAN link type? (Choose three.)
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which two types of devices are specific to WAN environments and are not found on a LAN? (Choose two.)
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which SNMP message type informs the network management system (NMS) immediately of certain specified events?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which command will backup the configuration that is stored in NVRAM to a TFTP server?
IT Questions Bank 7ITExamAnswers asked 4 years ago • 
What defines a two-tier spine-leaf topology?
IT Questions Bank 2IT Administrator asked 4 years ago • 
Which QoS mechanism allows delay-sensitive data, such as voice, to be sent first before packets in other queues are sent?
IT Questions Bank 2IT Administrator asked 4 years ago • 
A network technician has used the access-list 1 permit 172.16.0.0 0.0.0.255 command to configure NAT on an edge router to translate only four networks, 172.16.0.0 /24, 172.16.1.0 /24, 172.16.2.0 /24, and 172.16.3.0 /24. After receiving complaints about limited access to the Internet, issuing the show ip nat translations command reveals that some networks are missing from the output. Which change will resolve the problem?
IT Questions Bank 2IT Administrator asked 4 years ago • 
What is the effect of configuring the ipv6 unicast-routing command on a router?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
Refer to the exhibit. Which command will properly configure an IPv6 static route on R2 that will allow traffic from PC2 to reach PC1 without any recursive lookups by router R2?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
Match the description to the EIGRP packet type. (Not all options are used.)
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
Which statement describes the autonomous system number used in EIGRP configuration on a Cisco router?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
Which two metric weights are set to one by default when costs in EIGRP are being calculated? (Choose two.)
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
An EIGRP router loses the route to a network. Its topology table contains two feasible successors to the same network. What action will the router take?
IT Questions Bank 7ITExamAnswers asked 4 years ago • ,
« Previous1…113114115116117…167Next »
Ask Question