IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhich network plane is centralized and manages routing decisions?IT Administrator asked 3 years ago • CCNADrag and drop the QoS congestion management terms from the left onto the description on the right.IT Administrator asked 3 years ago • CCNADrag and drop the characteristics of network architectures from the left onto the type of architecture on the right.IT Administrator asked 3 years ago • CCNADrag and drop the SNMP manager and agent identifier commands from the left onto the functions on the rightIT Administrator asked 3 years ago • CCNABy default, how often does a Cisco switch that is using RSTP send out BPDU frames?ITExamAnswers asked 4 years ago • CCNA, CCNPWhat is the IP address of the switch virtual interface (SVI) on Switch0?Karlis Zakis answered 55 years ago • CCNARefer to the exhibit. An engineer configured the New York router with state routes that point to the Atlanta and Washington sites. When command must be configured on the Atlanta and Washington routers so that both sites are able to reach the loopback2 interface on the New York router?Pepe Gutierrez commented 3 years ago • CCNARefer to the exhibit. An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.IT Administrator asked 4 years ago • CCNADrag and drop the DHCP snooping terms from the left onto the descriptions on the right.IT Administrator asked 4 years ago • CCNAA network engineer is examining the configuration of a router and notices that interface Gi0/0 has been configured with the ip address dhcp command. Which statement describes the IP address condition of this interface?IT Administrator asked 4 years ago • CCNAWhat term describes holding packets in memory until resources become available to transmit them?IT Administrator asked 4 years ago • CCNAWhat characteristic completes the following statement? When an IPv6 static route is configured, as a default route, the destination network isIT Administrator asked 4 years ago • CCNAA network engineer is configuring a Cisco router as a DHCP relay. When issuing the ip helper-address command in the interface configuration mode which IPv4 address is added to the command?IT Administrator asked 4 years ago • CCNAThe PT initialization was skipped. You will not be able to view the PT activity. Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which task has to be performed on Router 1 for it to establish an OSPF adjacency with Router 2?ITExamAnswers asked 4 years ago • CCNAWhat action takes place when the source MAC address of a frame entering a switch appears in the MAC address table associated with a different port?ITExamAnswers asked 4 years ago • CCNA