IT Questions Bank

Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments
Tweet Share Pin it

IT Questions Bank 1

IT Questions Bank › Category: CCNA
What type of OSPF IPv4 route is indicated by a route table entry descriptor of O E1?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the purpose of a Cisco IOS 15 EM release?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator is analyzing first -hop router redundancy protocols. What is characteristic of VRRPv3?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What occurs when authentication is configured on an EIGRP router?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Match the OSPF router type description with its name
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What should be installed on a Cisco router as a prerequisite for installing the Data, Security, and Unified Communications licenses in IOS 15?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Which statement describes the load balancing behavior of EIGRP?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is the purpose of the Cisco License Manager?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network administrator is designing a wireless network for a new school building. The wireless network is for students using their own mobile devices. The network administrator wants to provide the most throughput possible even if the throughput is reduced by students using older devices. Which technology would be best in this situation?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit and the following error message from the SwB switch. 00:22:43: %SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk FastEthernet0/1 VLAN1 00:22:43: %SPANTREE-7-BLOCK_PORT_TYPE: Blocking FastEthernet0/1 on VLAN0001. Inconsistent port type. Considering that the link between the two switches is good and the correct type, what could cause this error message?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A company has deployed four 48-port access layer switches to a switch bock. For redundancy each access layer switch will connect to two distribution layer switches. Additionally, link aggregation will be used to combine 10 Gbps interfaces to form 20 Gbps trunk links form the access layer switches to the distribution layer switches. How many switch ports on the access layer switches will be available in the switch block to support end devices?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
Refer to the exhibit. The configuration shows commands entered by a network administrator for inter-VLAN routing. However, host PCA cannot communicate with PCB. Which part of the inter-VLAN configuration causes the problem?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
The exhibit shows this list of commands: Refer to the exhibit. Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
What is a characteristic of a default static route?​
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
A network engineer has been tasked with connecting two large autonomous systems (AS) together over the Internet. Which routing protocol should be selected?
IT Questions Bank 2ITExamAnswers asked 4 years ago • 
« Previous1…137138139140141…167Next »
Ask Question