IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNARefer to the exhibit. A network administrator has configured OSPFv2 on the two Cisco routers as shown. PC1 is unable to communicate with PC2. What should be done to fix the problem?ITExamAnswers asked 4 years ago • CCNAHow are externally learned EIGRP routes identified in the routing table?ITExamAnswers asked 4 years ago • CCNAWhich protocol does EIGRP use for the transportation of EIGRP packets?ITExamAnswers asked 4 years ago • CCNAWhich routing table descriptor is used to identify the OSPF networks advertised by type 1 LSAs?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which route or routes will be advertised to the router ISP if autosummarization is enabled?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. A network administrator would like to implement dynamic routing within a small network environment as shown in the exhibit. Which routing protocol would be a viable solution?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. What will Router1 do if it receives packets that are destined to network 2001:db8:11:100::/64?ITExamAnswers asked 4 years ago • CCNAWhich protocol does EIGRP use for the delivery and reception of EIGRP packets?ITExamAnswers asked 4 years ago • CCNAMatch each OSPF router type description with its name. (Not all options are used.)ITExamAnswers asked 4 years ago • CCNAWhat two conditions have to be met in order to form a cluster that includes 5 access points? (Choose two.)ITExamAnswers asked 4 years ago • CCNAA remote classroom can successfully access video-intensive streaming lectures via wired computers. However, when an 802.11n wireless access point is installed and used with 25 wireless laptops to access the same lectures, poor audio and video quality is experienced. Which wireless solution would improve the performance for the laptops?ITExamAnswers asked 4 years ago • CCNAUsers on an IEEE 801.11n network are complaining of slow speeds. The network administrator checks the AP and verifies it is operating properly. What can be done to improve the wireless performance in the network?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. When the show ip ospf neighbor command is given from the R1# prompt, no output is shown. However, when the show ip interface brief command is given, all interfaces are showing up and up. What is the most likely problem?ITExamAnswers asked 4 years ago • CCNAWhat are two methods to make the OSPF routing protocol more secure? (Choose two.)ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. If router B is to be configured for EIGRP AS 100, which configuration must be entered?ITExamAnswers asked 4 years ago • CCNA