IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAWhat type of OSPF IPv4 route is indicated by a route table entry descriptor of O E1?ITExamAnswers asked 4 years ago • CCNAWhat is the purpose of a Cisco IOS 15 EM release?ITExamAnswers asked 4 years ago • CCNAA network administrator is analyzing first -hop router redundancy protocols. What is characteristic of VRRPv3?ITExamAnswers asked 4 years ago • CCNAWhat occurs when authentication is configured on an EIGRP router?ITExamAnswers asked 4 years ago • CCNAMatch the OSPF router type description with its nameITExamAnswers asked 4 years ago • CCNAWhat should be installed on a Cisco router as a prerequisite for installing the Data, Security, and Unified Communications licenses in IOS 15?ITExamAnswers asked 4 years ago • CCNAWhich statement describes the load balancing behavior of EIGRP?ITExamAnswers asked 4 years ago • CCNAWhat is the purpose of the Cisco License Manager?ITExamAnswers asked 4 years ago • CCNAA network administrator is designing a wireless network for a new school building. The wireless network is for students using their own mobile devices. The network administrator wants to provide the most throughput possible even if the throughput is reduced by students using older devices. Which technology would be best in this situation?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit and the following error message from the SwB switch. 00:22:43: %SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk FastEthernet0/1 VLAN1 00:22:43: %SPANTREE-7-BLOCK_PORT_TYPE: Blocking FastEthernet0/1 on VLAN0001. Inconsistent port type. Considering that the link between the two switches is good and the correct type, what could cause this error message?ITExamAnswers asked 4 years ago • CCNAA company has deployed four 48-port access layer switches to a switch bock. For redundancy each access layer switch will connect to two distribution layer switches. Additionally, link aggregation will be used to combine 10 Gbps interfaces to form 20 Gbps trunk links form the access layer switches to the distribution layer switches. How many switch ports on the access layer switches will be available in the switch block to support end devices?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. The configuration shows commands entered by a network administrator for inter-VLAN routing. However, host PCA cannot communicate with PCB. Which part of the inter-VLAN configuration causes the problem?ITExamAnswers asked 4 years ago • CCNAThe exhibit shows this list of commands: Refer to the exhibit. Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface?ITExamAnswers asked 4 years ago • CCNAWhat is a characteristic of a default static route?ITExamAnswers asked 4 years ago • CCNAA network engineer has been tasked with connecting two large autonomous systems (AS) together over the Internet. Which routing protocol should be selected?ITExamAnswers asked 4 years ago • CCNA