IT Questions Bank Mar 16, 2020 Last Updated: Jun 29, 2023 No Comments Share Tweet Share Pin it IT Questions Bank › Category: CCNAA network manager wants to backup the running configuration to a file server. What command should the administrator use on a Cisco router?IT Administrator asked 4 years ago • CCNAWhat type of traffic is described as consisting of traffic that gets a lower priority if it is not mission-critical?IT Administrator asked 4 years ago • CCNAWhat type of address is 10.100.34.34?IT Administrator asked 4 years ago • CCNARefer to the exhibit. A network technician is troubleshooting connectivity issues in an Ethernet network with the command show interfaces fastEthernet 0/0. What conclusion can be drawn based on the partial output in the exhibit?ITExamAnswers asked 4 years ago • CCNAIn which type of attack does a malicious node request all available IP addresses in the address pool of a DHCP server in order to prevent legitimate hosts from obtaining network access?ITExamAnswers asked 4 years ago • CCNAWhich two basic functions are performed by network security tools? (Choose two.)ITExamAnswers asked 4 years ago • CCNAAn administrator wants to use a network security auditing tool on a switch to verify which ports are not protected against a MAC flooding attack. For the audit to be successful, what important factor must the administrator consider?ITExamAnswers asked 4 years ago • CCNAOpen the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which event will take place if there is a port security violation on switch S1 interface Fa0/1?ITExamAnswers asked 4 years ago • CCNAWhat impact does the use of the mdix auto configuration command haveon an Ethernet interface on a switch?ITExamAnswers asked 4 years ago • CCNAWhich type of cable does a network administrator need to connect a PC to a switch to recover it after the Cisco IOS software fails to load?ITExamAnswers asked 4 years ago • CCNAWhile troubleshooting a connectivity problem, a network administrator notices that a switch port status LED is alternating between green and amber. What could this LED indicate?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. What media issue might exist on the link connected to Fa0/1 based on the show interface command?ITExamAnswers asked 4 years ago • CCNAWhich protocol or service sends broadcasts containing the Cisco IOS software version of the sending device, and the packets of which can be captured by malicious hosts on the network?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Which S1 switch port interface or interfaces should be configured with the ip dhcp snooping trust command if best practices are implemented?ITExamAnswers asked 4 years ago • CCNARefer to the exhibit. Fill in the blank. There are ” 5*” broadcast domains in the topology.ITExamAnswers asked 4 years ago • CCNA